Ornate Blossom Cards {Shades of Blue}

I started out with inspiration from this card. Although this pattern from Greenhouse Gala DSP matches the Ornate Blossom stamp set, I could not figure out a way to use them together. It was overkill whenever I tried. By sticking with a small section of the paper however, it balances out and doesn’t make the pattern seem too bold.

Card base is Marina Mist, with a strip of Greenhouse Gala DSP paper pierced. I stamped the Ornate Blossom stamp in Marina Mist ink and the “just for you” in chocolate chip ink, from the Level 1 Hostess set Afterthoughts.

At the top, I used the corner rounder and tied some 1/4″ Chocolate chip twill ribbon (retired) around.

To add some more color, I attached three flower buttons with mini glue dots.

Along the same lines, I made this card using Ornate Blossom and Curly Cute stamp sets. The base is Marina Mist, with a strip of Greenhouse Gala DSP layered with chocolate chip card stock along the bottom.

I stamped the Ornate Blossom with chocolate chip ink on whisper white card stock and paper pierced all around with the paper piercer. Then, I layered it onto pear pizzaz card stock with stampin dimensionals.

The “thinking of you” is from Curly Cute, stamped in chocolate chip ink on whisper white. I added a pierced line below the words to coordinate with the main image.

For this last card, I stamped the Ornate Blossom stamp in Versamark on whisper white card stock and heat embossed it with White Embossing Powder. Then, I used the Brayer to add Pacific Point, Marina Mist, and Baja Breeze ink over the embossed image, darkest to lightest. Wipe the ink off the embossed image with a tissue.

Next, I stamped “for you” from Great Friends in Versamark and again, heat embossed it with White Embossing Powder. I paper pierced on either side of it with the paper piercer.

The main image was then matted onto whisper white card stock that I punched with the Scallop Edge Border Punch and paper pierced each scallop.

The card base is Baja Breeze, stamped with En Francais in Baja Breeze ink. I attached the whisper white layer to the base with stampin dimensionals and then added three pearls from Pearl Basic Jewels.